 | ||||
|
| ||||
Aligning the Rebel Machine Stripe Kit on Your CarThese photos show the correct alignment of the stripes on a Rebel Machine as well as the placement of the "The Machine" decals which go on the trunk and fenders.
We have marked the picture above with the locations where each of the closeup pictures below were taken so that you know which measurements apply.
| ||||
Aligning the Rebel Machine StripesPlease note that the measurements for the stripes are approximate because the lower part of the car body is curved so there is no clearly defined place from which to start measuring.
Picture 1 Aligning 'The Machine' DecalsOne 'THE MACHINE' decal goes on each of the front fenders.
On the right front fender (Passenger side), the decal is placed so that it is 1 1/4 inches below the red stripe so that the first letter of 'The Machine' starts 2 1/4 inches before the passenger door.
Left Front Fender (Driver Side) On the left front fender (Driver's side), the decal is placed so that it is 1 1/4 inches below the red stripe so that the last letter of 'The Machine' ends 2 1/4 inches away from the edge of the driver's door.
Placement of 'The Machine' on Trunk Picture 6 - Placement of 'The Machine' on Trunk The decal for the trunk goes close to the opening edge of the trunk about 1 1/2 inches from the right hand (passenger) side of the car.
| ||||
|
| ||||
|
AMCsheetmetal.ca RebelMachineStripeKit.com RebelMachineParts.com RebelMachine.ca
| ||||
|
| ||||
